.png)
The BLY34MDA Series is a compact construction that implements a DC Brushless controller and a DC Brushless motor in one streamline package. With the two part combined into one casing, the need to wire the motor has been eliminated. The DC Brushless controller operates off a 24VDC or 48VDC power supply. The high-speed DC Brushless motor can operate at 3200RPM, can generate up to 300 oz-in of continuous torque, and deliver as much as 700W, with the BLY34MDA4 offering. Using hall sensor feedback, the DC Brushless controller operates in a constant velocity mode. The driver is protected against over current (cycle-by-cycle), hall sensor error and under voltage. An external potentiometer (10K) or external voltage (0.5-5VDC) can be used to control the speed. The direction of the motor can be preset by the direction control input. A Stop function can be done by grounding the Run/Stop input.
Need to know the RPM of your motor? Check out our new SPDRO-4 speed readout module.
Keep your input voltage from rising too high due to internal mismatches while running your BLDC motor with our new PWR-24V/48V CLAMP active crowbar circuit.
- Requires 24-48VDC Input
- Maximum Current Limit Setting at 30.0 Amps (Peak)
- Constant Velocity Mode
- 0-5V External Voltage Speed Control
- 2-Quadrant Operation
- Hall Sensor Feedback
- Short Circuit Protection
- Run/Stop, Freewheel, and Direction Inputs
- Screw-Type Terminal Block
- TTL-CMOS Compatible Inputs
- Compact Size: 3.4" Square Motor Frame (Similar to NEMA 34)
.png)
.png)
.png)
.png)
.png)
.png)